6.2.1 Planning Imaging Observations

FLITECAM Imaging observations can be obtained in two different modes, Stare (we recommend using dithers ≥ 9 points) or Nod mode, depending on the target and astronomical background. Chopping is not used.

Stare mode observations involve a single telescope pointing centered on the source with many taken in a pattern relative to it to facilitate background subtraction and image calibration. Dithering can be performed by selecting from pre-programmed dither patterns, or by defining a custom pattern.

If the science target is extended or if it is located in a crowded region or region of extended emission, dithering alone may not be able to produce a suitable sky background frame. In this case the GI may elect to observe using Nod mode which will complete a dither on-source and then nod the telescope to a defined "sky" position and complete a dither there as well. Selection of the nod direction and amplitude depends on the field of view around the target and will need to be chosen carefully to access a clean "sky" position and allow proper background subtraction.

The observing efficiency for FLITECAM Stare mode observations with dithering is expected to be on the order of 70%. Observations in Nod mode are expected to result in a decrease in observing efficiency to around 35%. However, these efficiencies are built-in to the SOFIA Proposal Tool (SPT; further details in Section 11.1) and do not need to be specified by the GI.

Download the PDF Version

Share This Page